论文投稿Cover letter[通俗易懂]

论文投稿Cover letter[通俗易懂]转自:http://blog.sciencenet.cn/blog-479412-686426.html,感谢分享!1.第一次投稿Coverletter:主要任务是介绍文章主要创新以及声明没有一稿多投DearEditors:Wewouldliketosubmittheenclosedmanuscriptentitled“PaperTitle”,whichwewis…

大家好,又见面了,我是你们的朋友全栈君。

转自:http://blog.sciencenet.cn/blog-479412-686426.html,感谢分享!

1.第一次投稿Cover letter:主要任务是介绍文章主要创新以及声明没有一稿多投
Dear Editors:
We would like to submit the enclosed manuscript entitled “Paper Title”, which we wish to be considered for publication in “Journal Name”. No conflict of interest exits in the submission of this manuscript, and manuscript is approved by all authors for publication. I would like to declare on behalf of my co-authors that the work described was original research that has not been published previously, and not under consideration for publication elsewhere, in whole or in part. All the authors listed have approved the manuscript that is enclosed.
In this work, we evaluated …… (简要介绍一下论文的创新性). I hope this paper is suitable for “Journal Name”.
The following is a list of possible reviewers for your consideration:
1) Name A   E-mail: ××××@××××
2) Name B   E-mail: ××××@××××
We deeply appreciate your consideration of our manuscript, and we look forward to receiving comments from the reviewers. If you have any queries, please don’t hesitate to contact me at the address below.
Thank you and best regards.
Yours sincerely,
××××××
Corresponding author:
Name: ×××
E-mail: ××××@××××
二、催稿信:询问稿件处理到声明步骤
Dear Prof. ×××:
Sorry for disturbing you. I am not sure if it is the right time to contact you to inquire about the status of my submitted manuscript titled “Paper Title”. (ID: 文章稿号), although the status of “With Editor” has been lasting for more than two months, since submitted to journal three months ago. I am just wondering that my manuscript has been sent to reviewers or not?
I would be greatly appreciated if you could spend some of your time check the status for us. I am very pleased to hear from you on the reviewer’s comments.
Thank you very much for your consideration.
Best regards!
Yours sincerely,
××××××
Corresponding author:
Name: ×××
E-mail: ××××@××××
三、修改稿Cover letter
Dear Dr/ Prof..(写上负责你文章编辑的姓名,显得尊重,因为第一次的投稿不知道具体负责的编辑,只能用通用的Editors):
On behalf of my co-authors, we thank you very much for giving us an opportunity to revise our manuscript, we appreciate editor and reviewers very much for their positive and constructive comments and suggestions on our manuscript entitled “Paper Title”. (ID: 文章稿号).
We have studied reviewer’s comments carefully and have made revision which marked in red in the paper. We have tried our best to revise our manuscript according to the comments. Attached please find the revised version, which we would like to submit for your kind consideration.
We would like to express our great appreciation to you and reviewers for comments on our paper. Looking forward to hearing from you.
Thank you and best regards.
Yours sincerely,
××××××
Corresponding author:
Name: ×××
E-mail: ××××@××××
四、修改稿回答审稿人的意见(最重要的部分)
List of Responses
Dear Editors and Reviewers:
Thank you for your letter and for the reviewers’ comments concerning our manuscript entitled “Paper Title” (ID: 文章稿号). Those comments are all valuable and very helpful for revising and improving our paper, as well as the important guiding significance to our researches. We have studied comments carefully and have made correction which we hope meet with approval. Revised portion are marked in red in the paper. The main corrections in the paper and the responds to the reviewer’s comments are as flowing:
Responds to the reviewer’s comments:
Reviewer #1:
1. Response to comment: (……简要列出意见……)
Response: ××××××
2. Response to comment: (……简要列出意见……)
Response: ××××××
。。。。。。
逐条意见回答,切忌一定不能有遗漏
针对不同的问题有下列几个礼貌术语可适当用用:
We are very sorry for our negligence of ………
We are very sorry for our incorrect writing ………
It is really true as Reviewer suggested that……
We have made correction according to the Reviewer’s comments.
We have re-written this part according to the Reviewer’s suggestion
As Reviewer suggested that……
Considering the Reviewer’s suggestion, we have ……
最后特意感谢一下这个审稿人的意见:
Special thanks to you for your good comments.
Reviewer #2:
同上述
Reviewer #3:
    ××××××
Other changes:
1. Line 60-61, the statements of “……” were corrected as “…………”
2. Line 107, “……” was added
3. Line 129, “……” was deleted
    ××××××
    We tried our best to improve the manuscript and made some changes in the manuscript. These changes will not influence the content and framework of the paper. And here we did not list the changes but marked in red in revised paper.
We appreciate for Editors/Reviewers’ warm work earnestly, and hope that the correction will meet with approval.
Once again, thank you very much for your comments and suggestions.
五、文章接受后可以考虑感谢一下负责你文章的编辑或主编(根据需要)
Dear Prof. ××××××:
Thanks very much for your kind work and consideration on publication of our paper. On behalf of my co-authors, we would like to express our great appreciation to editor and reviewers.
Thank you and best regards.
Yours sincerely,
××××××
Corresponding author:
Name: ×××
E-mail: ××××@××××
六、询问校稿信件(如果文章接受后时间较长)
Dear ×××:
Sorry for disturbing you. I am not sure if it is the right time to contact you to inquire about the status of our accepted manuscript titled “Paper Title” (ID: 文章稿号), since the copyright agreement for publication has been sent to you two months ago. I am just wondering that how long I can receive the proof of our manuscript from you?
I would be greatly appreciated if you could spend some of your time for a reply. I am very pleased to hear from you.
Thank you very much for your consideration.
Yours sincerely,
××××××
Corresponding author:
Name: ×××
E-mail: ××××@××××
七、文章校稿信件
Dear Mr. ×××:
Thanks very much for your kind letter about the proof of our paper titled “Paper Title” (ID: 文章稿号) for publication in “Journal Name”. We have finished the proof reading and checking carefully, and some corrections about the proof and the answers to the queries are provided below.
Corrections:
1. In ****** should be **** (Page ***, Right column, line***)
2. In **** the “*****” should be “****” (Page ****, Right column, line****)
Answers for “author queries”:
1. *********************.
2. **********************
3. **********************
We greatly appreciate the efficient, professional and rapid processing of our paper by your team. If there is anything else we should do, please do not hesitate to let us know.
Thank you and best regards.
Yours sincerely,
××××××
Corresponding author:
Name: ×××
E-mail: ××××@××××

转载于:https://www.cnblogs.com/baiting/p/8667106.html

版权声明:本文内容由互联网用户自发贡献,该文观点仅代表作者本人。本站仅提供信息存储空间服务,不拥有所有权,不承担相关法律责任。如发现本站有涉嫌侵权/违法违规的内容, 请发送邮件至 举报,一经查实,本站将立刻删除。

发布者:全栈程序员-用户IM,转载请注明出处:https://javaforall.cn/134731.html原文链接:https://javaforall.cn

【正版授权,激活自己账号】: Jetbrains全家桶Ide使用,1年售后保障,每天仅需1毛

【官方授权 正版激活】: 官方授权 正版激活 支持Jetbrains家族下所有IDE 使用个人JB账号...

(0)


相关推荐

  • 在pycharm中配置anaconda环境_anaconda pycharm环境配置

    在pycharm中配置anaconda环境_anaconda pycharm环境配置在pycharm中如果出现了nopythoninterpreterconfiguredfortheproject表示你没有给这个工程提供一个解释器如果已经安装pychrm在后期怎么配置解释器呢:![在这里插入图片描述](https://img-blog.csdnimg.cn/20210713171532445.png)file中选择setting然后点击右边的设置,Add进行配置,还是进入systeminterpreter,需要注意的是在Pycharm中选择错了anaconda.

  • LaTeX 中插入数学公式

    LaTeX 中插入数学公式转载自:一、常用的数学符号1、小写希腊字母下面的都要上面这个案例一样才有用。为了方便书写,以下两边都只写了一个$,而实际上两边要写$$才有用,如:对应α\alphaα2、大写希腊字母 大写希腊字母只需要将小写希腊字母的第一个英文字母大写即可。但是需要注意的是,有些小写希腊字母的大写可以直接通过键盘输入,也就是说和英文大写是相同的。3、运算符 对于加减除,对应键盘上便…

  • CentOS7使用iptables防火墙开放端口

    CentOS7使用iptables防火墙开放端口

    2021年10月29日
  • 最全面的外包公司的解释

    最全面的外包公司的解释1.最新北京软件外包公司排行榜软件外包企业排名:北京华盛恒辉科技有限公司(北京)北京五木恒润科技有限公司(北京)东软集团Neusoft(沈阳)博彦科技BeyondSoft(北京)海辉软件HiSoft(大连)文思VanceInfo(北京)浙大网新Insigma(杭州)奥博杰天Objectiva(北京)浪潮Inspur(济南)软通动力iSoftStone(北京)2.国内一些比…

  • java输入Scanner基本用法[通俗易懂]

    java输入Scanner基本用法[通俗易懂]1.基本介绍java.util.Scanner是Java5的新特征,我们可以通过Scanner类来获取用户的输入,每个next获取输入对应的字符。Scannersc=newScanner(System.in);当我们通过Scanner类的next()与nextLine()方法获取输入的字符串,在读取前我们一般需要使用hasNext与hasNextLine判断是否还有输入的数据:next()–>hasNext() nextLine()–…

  • 最新Spring整合MyBatis详解教程

    最新Spring整合MyBatis详解教程目录1.导入相关jar包1.junit2.mybatis3.mysql4.spring相关5.aop织入6.mybatis-spring7.lombok(选用)2.回顾:建立一个Mybatis程序1.IDEA连接数据库2.编写MyBatis核心配置文件3.创建数据库表对应实体类4.编写Mapper接口5.编写Mapper.xml配置文件6.编写测试类7.给Mapper.xml添加注册8.测试运行3.spring整合方式一:1.引入spring配置文件2.使用Sprin

发表回复

您的电子邮箱地址不会被公开。

关注全栈程序员社区公众号